The Xtool D1 Pro is a great laser to engrave our maps. Its relatively low cost compared to most CO2 Lasers and ability to expand the bed to about 36" x 16" means that its an excellent laser to engrave large wall pieces with.
This is a screensnap of the settings used with the Lightburn software to get a good engrave with Xtool D1 – it takes about 4.5 hrs to engrave a 14″ x 11″ maple board
The engraving with the diode laser is often darker than one engraved with a CO2 laser.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article